Otter Creek LabsMilkman
9mm / .36 Cal suppressor · HUB 1.375x24 interface · specs and compatibility from the manufacturer
Notable features
- HUB Compatible
- Low Backpressure
- No Barrel Restrictions
- TBAC Summit Tested
- Full-Auto Rated
length
6″
weight
8.8oz
MSRP
$950
length
6″
weight
8.8oz
calibers
9mm | .35
material
Titanium
interface
HUB 1.375x24
MSRP
$950
- Overall length
- 6″
- Diameter
- 2″
- Class
- 9mm / .36 Cal
- n
- 250
- Range
- 1″–2.13″
- Median
- 1.5″
- Weight
- 8.8 oz
- Material
- Titanium
- Max caliber
- 9mm
- Rated cartridges
- 9mm, 38 special, 350 Legend, 32 acp, 8.6 blk, 338 ARC
- Base interface
- HUB 1.375x24
- Front cap
- Fixed
- Backpressure
- Low
- Full-auto rated
- Yes
- Barrel restriction
- None (manufacturer stated)
- On 9mm
- Firing limit
- Full-auto; no barrel length restrictions on 9mm
- Handgun booster
- Not intended for handguns
- MSRP
- $950
Wider than most 9mm / .36 Cal suppressors
Diameter compared against the 250 9mm / .36 Cal suppressors in the catalog that publish one. Quartile basis; a value inside the middle half carries no note.
Prices are manufacturer's suggested retail (MSRP). What you pay may differ.
Is something on this page wrong?
- Base interface
- HUB 1.375x24
- Front cap
- Fixed
The HUB 1.375x24 is an open standard: 494 mounts and 940 muzzle devices in our catalog fit this suppressor, including Otter Creek Labs HUB Direct Thread Adapter (1/2x28), AAC 51T S.T.A.M.P. Mount and AB Suppressor AB Raptor Adapter. You aren't locked into one manufacturer's parts.
Which ones fit your barrel and host?
Check in the BuilderThe Thunder Beast Silencer Summit fires every suppressor entered on the same gun, with the same equipment. Milkman was measured in 2 tests. Figures can only be compared with others from the same test, so each one links to everything else fired on that gun.
Bolt-action and lever rifles
Measurements published by Thunder Beast Arms Corp. How to read these
Manufacturer claim
- For 9mm-ish sized projectiles only: 375/38 special, 350 Legend, 9mm, 32 acp, 8.6 blk, 338 ARC, etc. Titanium, 2 inches on the thick part and 1.5 inches on the thin part, HUB/1.375x24 thread pitch.
- Built as a tribute: OCL's Ethan (″Milkman″) wanted a low back pressure 9mm suppressor for his direct-blowback 9mm AR9 — the combination of lefty shooter, direct blowback, and the Lithium would gas him out.
- A low back pressure 9mm suppressor for rifle/SMG/PCC use — run it with any full auto SMG or FRT, with no barrel length restrictions on 9mm.
- What comes in the box: suppressor, tube clamp, stickers — no mount is included; you must buy and supply your own mount.
Show all 5 ▾ ▴
- Pistol/handgun/booster use is NOT covered under warranty and is not recommended.
Is one of these wrong, or does our wording say something the source doesn't?
